Part Names And Functions - Panasonic PN290496-NZ Installation Manual

2

Part Names and Functions

Back panel
MAC Address label
Front panel
Serial Number label
 Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
 Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
 Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
 100BASE-TX/1000BASE-T/2.5GBASE-T/5GBASE-T ports supporting PoE power
supply (ports 1 - 4)
A PoE power supply which is IEEE802.3bt/at/af compatible is usable.
100BASE-TX/1000BASE-T/2.5GBASE-T/5GBASE-T terminals, hubs, repeaters, bridges,
Ethernet Switches, etc. are connectable. Lay out the twisted pair cables (CAT5e or
higher) so that the cable lengths fit within 100 m.
 100BASE-TX/1000BASE-T/2.5GBASE-T/5GBASE-T/10GBASE-T ports + SFP+
expansion slots (ports 5, 6)
SFP expansion modules can be mounted. (They are exclusively used with the twisted
pair ports.)
They automatically switch when the SFP+ expansion slots are linked.
Lay out the twisted pair cables (CAT6 or higher) so that the cable lengths fit within
100 m. The SFP ports only support full duplex.
 Console port
Connect a VT100 compatible terminal, etc. with this port to configure or manage
this Ethernet Switch.
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
Flow control
12
Power port
100BASE-TX/1000BASE-T/2.5GBASE-T/5GBASE-T ports supporting PoE power supply
100BASE-TX/1000BASE-T/2.5GBASE-T/5GBASE-T/10GBASE-T ports
: 1 bit
: None
Ground terminal Power cord hook block
Emulation mode
Data length
Parity control
Transmission connector : RJ45
SFP+ extension slots
Console port
: VT100
: 8 bits
: None