Table of Contents
Advertisement
Part Names and Functions
2
Power cord hook block
Back panel
LED display change button
Front panel
Enlarged view on the next page
Explanation label
Power port
Connect the supplied power cord to this port and connect the other end into an
electric outlet.
Power cord hook block
If the supplied power cord is hanged to this block, the cord becomes hard to pull
out from the power port.
Ground terminal
Only qualified personnel should install minimum 18AWG green-and-yellow stranded
copper wire to Ground terminal screw.
10/100/1000BASE-T port (ports 1–22)
Devices such as 10/100/1000BASE-T terminal, hub, repeater, bridge, and Ethernet
Switch can be connected to this port. Install the device so that the length of twisted
pair cable (CAT5e or above) becomes 100 m or less.
10/100/1000BASE-T port + SFP extension slot (ports 23, 24)
Install SFP extension module here. (It becomes exclusive usage with twisted pair
port.)
When SFP extension slot is linked, the port is automatically switched to SFP
extension mode.
SFP port supports only the full duplex communication.
Console port
Transmission mode : RS-232C
Transmission speed : 9,600 bps
Stop bit
Flow control
Use our optional RJ45-DSub 9-pin console cable for the console cable.
10
G
r
o
u
n
d
t
r e
m
n i
l a
10/100/1000BASE-T port
Emulation mode
Data length
: 1 bit
Parity control
: None
Transmission connector : RJ45
P
o
w
r e
p
o
t r
MAC address label
S
e
i r
l a
SFP extension slot
: VT100
: 8 bits
: None
n
u
m
b
r e
a l
b
l e
Console port
Advertisement
Table of Contents
