Table of Contents
Advertisement
ACCESSORY CONNECTIONS
Magnetic Lock, Lock Solenoid
Power for the Locks:
Do not use the 24VDC power supplied
by the Control Board. A Class 2 external
power supply or plug-in transformer, must
be used for the magnetic lock or lock
solenoid. This will prevent rapid drainage
of the battery in the event of power failure.
The control boards "Magnetic Lock " relay
is rated for 10A-250VAC .
!
TECHNICAL TIP:
The Magnetic Lock Relay
LED will indicate status of the on-board
relay even if a lock is not connected to
the Control Board. Refer to page 36.
3 4
Magnetic Lock
Lock Solenoid
VIKING TECHNICAL SUPPORT 1.800.908.0884
Advertisement
Table of Contents
