Control - Dometic POWER AWNING PRO Installation And Operation Manual

Wireless Remote Control/Receiver & Wind Sensor
NOTICE: Do not hang any items from, or block the
travel of, the hardware arms or awning when the wind
sensor is installed.
This section describes how to pair the wind sensor to the
receiver and to the remote control. The wind sensor is a
key component to protect your awning from the wind.
I For safety purposes, the wind sensor sends a
signal to the receiver every 60 minutes to confirm
functionality. lf for any reason (removal, low battery,
etc.) the signal is not received after 60 minutes, the
awning will retract automatically.
The information below applies to all compatible power
awning pro models.
Complete each pairing step within four seconds
I
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
9 .1 Pairing the Wind Sensor to the
Remote Control
Step Operation
1
Remove the front
cover of the wind
sensor.
2
Set the Sensor Dial
to 0.
3
Press the remote
control Left P2 button
one time.
EN
Audible Awning
Alert Movement
None None
None None
Beep x1 Awning
jogs
Pairing the Wind Sensor (If Applicable)
Step Operation
4
Press the remote
control Left P2 button
one time.
5
Press the Sensor
Programming
button one time.
6
Set the Sensor Dial
to 5 .
7
Press the Sensor
Programming
button one time.
8
Set the Sensor Dial
to desired level.
Audible Awning
Alert Movement
None
Beep x1
Sensor Awning
Beep xl jogs
and
Receiver
Beep x5
None None
Sensor Awning
Beep xl retracts
None None
11