Table of Contents
Advertisement
5 5 . . 0 0
INSTRUCTION for USE
5.1
Initial Operation
5.2
Temperature Control
Interior Light (
5.3
When the door is opened, the LED-lighting in the cooling shelf is switched
on via a sensor.
LIGHTING TO BE EXCHANGED BY SERVICE PERSONNEL ONLY.
Changing the printed board with LEDs:
1. Pull out the
mains plug
4. Insert new LED-board
To obtain spare bulbs, please contact your Dometic Service Centre.
RHC 860AC:
Please refer to the installation advices of the AMS system manual!
The temperature in the cooling
compartment can be regulated
with a thermostat.
The thermostat control button is
situated in the compartment's rear
area.
when fitted
2. Remove the reflector
disk.
The device must be plugged into a properly
earthed socket.
The miniBar achieves its operating
temperature after approx. one hour.
)
5. Clip reflector disk
back in
9
3. Remove defective
LED-board.
Advertisement
Table of Contents
