Operation; Using The Remote Control; Troubleshooting - Dometic POWER AWNING PRO Installation And Operation Manual

Wireless Remote Control/Receiver & Wind Sensor

11 Operation

This section describes how to operate and adjust the
awning using the remote control.

11 .1 Using the Remote Control

e
r
t
11 Remote Control
Button
Up Retracts the awning when the button is
q
pressed and held.
Stop • For 9100 awnings only: Stops awning
w
movement if programmed for One
Touch mode. See "Pairing the 9100
Remote Control" on page 10.
• Clears memory. See "Clearing the Wind
Sensor Memory" on page 12
Down Extends the awning when the button is
e
pressed and held.
LED Turns the LED light(s) on and off.
r
LED - Dims the LED light(s).
t
LED + Brightens the LED light(s).
y
1. To extend the awning, press the Down button until
the awning is fully deployed position.
2. To stop deploying the awning, release the Down
button.
3. To adjust the awning extension, press the Up or
Down button to jog back to the preferred deployed
position.
EN
w
q
y
Function
.

12 Troubleshooting

Problem Possible Cause
The remote The receiver
control is unable has reset before
to pair the remote initiating the next
control or wind step in the pairing
sensor. process.
The wind sensor The wind sensor
keeps beeping; battery may be
the awning low. (The receiver
automatically will retract the
retracts every 30 awning every 30
minutes. minutes to protect
the awning.)
The wind sensor The wind sensor
does not function. is not attached to
the wind sensor
base.
The awning The wind sensor is
automatically out of place.
retracts every 60 (The receiver will
minutes. retract the awning
every 60 minutes
to protect the
awning.)
For 9100 awnings The wind sensor is
only: activated, but the
The awning motor remote control is
continues to not programmed
retract when the for One Touch
awning is already mode.
retracted.
The LED lights do For a receiver
not illuminate. installation on an
existing awning
with LEDs, the
existing LED
switch was not
disconnected.
The 3 A auto-reset
fuse has blown to
protect the LED
strip from a short-
or over- current
condition.
Operation
Recommended
Solution
Restart the pairing
process and
complete each
step within four
seconds of the
previous step.
Replace the wind
sensor battery.
Locate the wind
sensor and
reattach it to the
wind sensor base.
Locate the wind
sensor and put it
back in place.
Program the
remote control for
One Touch mode
using steps 4-8 in
"Pairing the 9100
Remote Control"
on page 10.
Connect the
LED switch. See
"Installing the
Receiver" on
page 7.
1. Disconnect
the power
using the On/
Off switch.
2. Determine and
fix the cause
of the blown
fuse.
3. Turn the unit
on using
the On/Off
switch.
13