Pairing The Remote Control; Pairing The 9200 And 9500 Remote; Controls - Dometic POWER AWNING PRO Installation And Operation Manual

Wireless Remote Control/Receiver & Wind Sensor
7 .2 .3 Completing the Wind Sensor
Installation for all Awnings
1. Re-install the wind sensor onto the wind sensor base.
9 Raising and Lowering the Roller Tube
Wind Sensor Location
q
2. Rapidly raise and lower the roller tube to activate the
wind sensor.
At activation, the awning will close completely.

8 Pairing the Remote Control

This section describes how to pair the power awning
remote control to the receiver and, if applicable, to the
wind sensor.
The power awning remote control must be paired with
the receiver to communicate. The pairing steps may vary
depending on the awning model. Follow the pairing
instructions for your awning model.
EN
8 .1 Pairing the 9200 and 9500
Remote Controls
This section describes how to pair the 9200 and 9500
awning series only.
I
q
Step
1
2
3
4
5
Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Operation
Remove the battery
cover from the back of
the remote.
Turn the receive
Power button ON.
Press the Left P2
button two times.
For 9200 only:
Press the Up button
one time.
For 9500 only:
Press the Down
button one time.
Proceed immediately to "Verifying the Remote
Control Functions" on page 10.
Pairing the Remote Control
Audible Awning
Alert Movement
None None
None
Beep xl
None
Beep x2
Beep x4 Awning
jogs
9