Pairing The 9100 Remote Control; Verifying The Remote Control Functions; Pairing The Wind Sensor (If Applicable) - Dometic POWER AWNING PRO Installation And Operation Manual

Pairing the Wind Sensor (If Applicable)

8 .2 Pairing the 9100 Remote Control

This section describes how to pair the 9100 awning
series only.
I Complete each pairing step within four seconds
of the previous step to keep the receiver in pairing
mode. If the receiver resets, restart the pairing
process.
Step Operation
1
Remove the battery
cover from the back of
the remote.
2
Turn the receive
Power button ON.
3
Press the Left P2
button two times.
4
1
Press the Up button
one time.
5
1
Press the Left P2
button one time.
6
1
Press the Up button
one time.
10
Audible Awning
Alert Movement
None None
None
Beep xl
None
Beep x2
Beep x4 Awning
jogs
Beep x1 Awning
jogs
None
Beep x1
Wireless Remote Control/Receiver & Wind Sensor
Step Operation
7
1
Press Down button
one time
8
1
Press Left P2 button
one time
9 Proceed immediately to "Verifying the Remote
Control Functions" on page 10.
1
For 9100 awnings only: Steps 4-8 represent the One Touch programming
procedure.
8 .3 Verifying the Remote Control
Functions
This section describes how to verify remote control
functionality after pairing the remote control and the
receiver.
To verify remote control functionality:
1. Press the Down button. The awning should extend.
2. Press the Up button. The awning should retract.
If either button does not perform as expected, see
"Pairing the Remote Control" on page 9 and
restart the pairing process.
3. Upon successful verification, proceed to "Pairing the
Wind Sensor (If Applicable)" on page 10.
9 Pairing the Wind Sensor (If
Applicable)
NOTICE: Do not rely on the wind sensor to prevent
damage to the awning. The awning should always be
closed when unattended or when strong rain, wind, etc.
is expected.
Audible Awning
Alert Movement
None None
Beep x1 Awning
jogs
EN