Tunstall MXD User Manual page 18

Spoken Message
Factory test
mode
Hold HELP to
turn off
Monitor Mode
Please check power
connection
Please Service Unit
Program Medication
Dispenser
Programming mode
Program CO
Detector
Meaning
The T/L button has been
pressed with the RESET
button pushed at the
same time, placing the
unit in Factory Test Mode.
The MXD base unit is ready
to be turned off.
The unit is in a special
mode that allows a trained
technician to listen to the
signals transmitted to the
network and response
center.
The base unit is
unplugged from the wall
or the AC power circuit is
not energized.
The MXD has been
disabled by the
response center or has
malfunctioned.
The unit is ready to be
programmed to accept
signals from a medication
dispenser.
The unit is in an advanced
mode for programming.
The unit is ready to be
programmed to accept
signals from a carbon
monoxide detector.
Suggested Action
Press the RESET button to
restore the unit to normal
operation.
Push the HELP button on
top of the base unit to
complete the power- down
sequence. If you do not wish
to power-down the unit,
press the RESET button.
For provider use only.
Press the RESET button to
exit this Mode.
Verify the power block
is plugged into a live AC
outlet that is not controlled
by a light switch.
The unit needs
replacement. Contact
technical Support or your
service provider.
Press the RESET button
to exit this mode. This
feature will not be used.
For provider use only. Press
the RESET button to exit
this mode.
Press the RESET button
to exit this mode. This
feature will not be used.
18