Snmp Commands; Rfid Commands - Paxar 9860 Operating Instructions Manual

S N M P C o m m a n d s
CLear SNMP CONtact <string>
Removes SNMP SysContact.
CLear SNMP LOCation <string>
Removes SNMP SysLocation.
SET SNMP GETCOMM
Gets SNMP community.
SET SNMP SETCOMM1 <string> or SET SNMP SETCOMM2
<string>
Sets SNMP community 1 or community 2 name.
Note: An incoming set request can use either name for comm1 or
comm2.
SET SNMP CONtact
Sets SNMP SysContact.
SET SNMP LOCation <string>
Sets SNMP SysLocation.
SET SNMP JETADmin [EN|DIS]
Selects whether to use the JetAdmin protocol.
R F I D C o m m a n d s
SET PRN RFId [WRiteattempts/ PRotocol/ SIgnal/
RPower/ WPower] value
Sets the specified RFID parameter to the specified value.
SHow PRN RFId {MOduletype/ VErsion/ WRiteattempts/
PRotocol/ SIgnal/ RPower/ WPower/ REgion/
FRequency/ SUmmary/ COnfiglabel}
Shows the specified RFID parameter's current setting. If no parameter is
specified, it shows the current settings of all parameters in the RFID
category.
SHow RFId LOG
Shows the RFID log.
CLear PRN RFId SUmmary
Clears RFID summary data (number of good and bad RFID tags).
4-22 MonarchNet2 Operating Instructions
<string>
<string>