Paxar 9860 Operating Instructions Manual page 40

Set the Skip Index mode: No or Yes. Skip index allows you to
7.
print an image over multiple labels.
8. Set the Backfeed: Off, On, or Extended. Backfeed advances
each printed label to the specified dispense position and then
backs up the next label to be printed underneath the printhead.
Do not use extended backfeed on non-knife printers.
9. Enter a value for the Dispense Position (range is 50 to 200).
This adjusts the stopping point of the label after it is printed.
10. Enter a value for the Backfeed Distance (range is 10 to 200).
This is the amount to move the label backwards before printing.
11. Enter a value for the Contrast (range is –699 to 699). This
adjusts the darkness of printing on the supply.
12. Enter a value for the Print Position (range is –450 to 450). This
adjusts where data prints vertically on the supply.
13. Enter a value for the Margin Position (range is –99 to 99). This
adjusts where data prints horizontally on the supply.
14. Click Submit when finished.
3-6 MonarchNet2 Operating Instructions