Table of Contents
Advertisement
Lab-Line Imperial III General Purpose Incubators are useful in all types of
general incubating and paraffin imbedding.
Cabinets are made of heavy-gauge steel with a powder-coated finish for optimum
appearance and easy cleaning, while the interior walls are stainless steel to spread warm-
wall radiant heat evenly throughout the chamber. Sheathed, low-watt density heaters are
in direct contact with chamber walls to allow close temperature control and quick
recovery after door openings. This arrangement also minimizes temperature gradients
and offers a large working area in the chamber.
A double set of doors, the inner of tempered glass, permits unobstructed viewing
of chamber contents without disturbing the interior environment. Slide-out shelving can
be positioned to meet user requirements.
A PID microprocessor based controller maintains chamber temperature. An over-
temperature safety thermostat controls temperature in the event of primary control failure.
A status lamp above each control is lit when the respective control is maintaining power
to the heaters.
Incubators are available in three sizes. A grounded 3-prong convenience outlet is
supplied in midsize model chambers and 2 outlets are installed in larger models. Models
are built for either 120 VAC or 240 VAC power requirements. Models 305M, 306M,
310M and 311M have the same characteristics as those listed above but, in addition,
provide mechanical convection. These models use a blower and plenum design to
circulates the air within the chamber that allows for rapid temperature and uniformity
recovery after door openings.
DESCRIPTION
MODEL 302
SECTION 2
7
Hide quick links:
Advertisement
Table of Contents
