Smart bidet tankless toilet elongated one piece chair height, auto flush, foot sensor operation, heated seat with integrated multi function remote control in white (3 pages)
Content WOODBRIDGE Safety precautions List of materials Technical drawings Required accessories for in-wall hanger Installation toolings Dimension of installation position Pre-installation confirmation Before installation Procedures www.woodbridgebath.com...
SAFETY PRECAUTIONS WOODBRIDGE When using electrical products, especially when children are present, basic safety precautions should always be followed, including the following: 1. This product is not intended for children (without proper adult supervision). 2. This product is not intended for individuals with reduced physical, sensory, or mental capabilities.
Page 4
IMPORTANT SAFETY INSTRUCTIONS CAUTION – Failure to follow the instructions may cause bodily injury orproperty damage. 1. Do not install or use the product in wet or damp locations such as a steam room. 2. Ensure the electrical outlet is positioned where it will not come in contact with water. 3.
Page 5
Part List WOODBRIDGE Main Unit Remote control INSTALLATION MANUAL WOODBRIDGE ELECTRONIC WASHLET TOILET :B0999S Compliance with the following codes & standard: ® ( UPC ) • 2015 Uniform Plumbing Code ® ( IPC ) • 2018 International Plumbing Code ®...
Pre-installation confirmation Installation Methods Circuit pre-installation: Install a fixed power supply line ( The line includes: neutral line, live line, ground line) ·Confirm the electrical connection location. ·Reserve the pipeline for power line. Pre-installation of the circuit breaker ·Connect a separate upstream circuit breaker. ·Pre-connect an earth leakage circuit breaker or grounding protector for other independent lines.
WOODBRIDGE Before installation 1. Minimum static working water pressure: above 0.08MPa (Above 2.25G/8.5L min flow)failure to meet this pressure will not achieve the best flushing effect. Note: If there is not the water pressure test device, please refer to the following method.
Page 11
Before installation WOODBRIDGE 3. Installation of power switch Tips: Please install the power switch in accordance with the circuit breaker instruction after the power is turned off (the circuit breaker is not supplied and to be purchased by installer or customer).
Procedures WOODBRIDGE Remove the package,and check 2. Remove the screws and washers after all the parts are included before opening the top cover and seat installation. 3. Remove the seat cover after closing the lid and the seat ring, protect the appearance www.woodbridgebath.com...
Page 13
Procedures WOODBRIDGE 4. Confirm the length of the flushing 5. Trim off excessive tube length tube 3 /16" Confirm the length of the drain Trim off excessive tube length pipe 1/8" www.woodbridgebath.com...
Page 14
Procedures WOODBRIDGE Apply lubricant oil to the nozzle after 8. Sharpen the end faces of the two polishing. elbows with file saws and remove the edges. Put on the pad Take out the connecting bolt cover, apply lubricant oil to the pipe in the wall and the pipe opening of the drain pipe.
Page 15
Procedures WOODBRIDGE The flushing pipe and the drain Apply lubricant on the flushing pipe are inserted separately into pipe and the drain pipe. the wall. Put the braided tube, "connecting Align the toilet with the bolt line of the off seat flushing" and the holes against the wall.
Page 16
Procedures WOODBRIDGE Leveling the toilet with a level on Lock and secure the gaskets and top of the toilet nuts with spanner Trim off excessive pad Apply a bead of silicone caulking around the toilet www.woodbridgebath.com...
Page 17
Procedures WOODBRIDGE 20. Tightly screw the connector of the electronic cover and the toilet. The electronic seat and the toilet water supply hose are connected through a ball valve. The off-seat auto flushing punching cable passes through the middle of the two pipes, and then the two hook&loop are inserted and tightened with the...
Page 18
Procedures WOODBRIDGE 22. Wrap the strip-shaped hook&loop around the water supply hose and the power cord coupler, and then stick them to the hook&loop positions affixed to the sides of the toilet in advance. Open the lid and the seat ring, lock the screws, and insert the decorative cap.
Page 19
Thank you for using WoodBridge products! Customer Service Phone: 562-229-0088. (Monday - Friday 9 AM - 5 PM Pacific Time) Or Email: help@woodbridgebath.com www.woodbridgebath.com ASVFA72160013A-1.0...
Need help?
Do you have a question about the LT611 and is the answer not in the manual?
Questions and answers