Woodbridge B0940 Installation Instructions Manual

Woodbridge B0940 Installation Instructions Manual

One piece toilet
Hide thumbs Also See for B0940:

Advertisement

ONE PIECE TOILET
B0940
MPN:
INSTALLATION INSTRUCTIONS

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B0940 and is the answer not in the manual?

Questions and answers

Summary of Contents for Woodbridge B0940

  • Page 1 ONE PIECE TOILET B0940 MPN: INSTALLATION INSTRUCTIONS...
  • Page 2: Tools Required For Installation

    ONE PIECE TOILET READ ALL INSTRUCTIONS BEFORE UNPACKING THE PRODUCT INSTRUCTIONS THAT, IF IGNORED COULD RESULT IN DEATH OR SERIOUS INJURY CAUSED BY INCORRECT HANDLING OR INSTALLATION OF THE PRODUCT. THESE INSTRUCTIONS MUST BE OBSERVED FOR SAFE INSTALLATION. 2 PEOPLE ARE REQUIRED TO LIFT AND DURING ENTIRE INSTALLATION OF THIS PRODUCT INSTALLATION OF THIS PRODUCTS BY AN INEXPERIENCED INSTALLER MAY RESULT...
  • Page 3: Dimensions/Technical Data

    ONE PIECE TOILET DIMENSIONS/TECHNICAL DATA 28 1/2" 2 1/2" 14 1/4" 7 1/4" 2" 1 1/2" 18" 5 1/2" Rough-in 12" Standard ATTENTION! Dimensions may vary by up to 3/8". It is highly recommended to pull all dimensions of actual model for installation and measuring purposes. TECHNICAL DATA •...
  • Page 4 ONE PIECE TOILET WATER SUPPLY LOCATION & TECHNICAL INFORMATION Side View Back View Threaded Shunk (Water Supply Fill Valve) Supply Position 1 15" Supply 3" Position 2 5 1/2" 5 1/2" Floor 12" 5 1/2" Rough-in 4 1/2" 12" Standard 10"...
  • Page 5: Installation Instructions

    ONE PIECE TOILET INSTALLATION INSTRUCTIONS IMPORTANT! Shut off main water supply prior to installation! REMOVE OLD TOILET 1. Shut o water supply line. If you do not have shut-o valve near the toilet shut o main water supply line. 2. Flush the old toilet and make sure that tank is empty. 3.
  • Page 6 ONE PIECE TOILET INSTALLATION INSTRUCTIONS INSTALL NEW TOILET Step 1. Lift and carefully put the toilet over the closet ange so the closet bolts can go through the mounting holes in the toilet's base. Once the bowl is in the position press the bowl down with slight twisting motion in level position towards the oor.
  • Page 7 ONE PIECE TOILET TOILET SEAT ADJUSTMENT...
  • Page 8: Troubleshooting

    ONE PIECE TOILET ADJUSTMENT & MAINTENANCE (DUAL FLUSH VALVE) Important Note: Flush GPF amount is factory set. No additional adjustment is required. This page is for reference only. All adjustments are already made by manufacturer. 1. BASE INSTALLATION Gasket Check the dual ush Install the base with the Install a body of the ush Rotate the valve...
  • Page 9: Water Level Adjustment

    ONE PIECE TOILET ADJUSTMENT & MAINTENACE (FILL VALVE) Important Note: Flush GPF amount is factory set. No additional adjustment is required. This page is for reference only. All adjustments are already made by manufacturer. Instructions: 95mm When valve installed, the critical level mark on ll valve (identi ed by C.L.
  • Page 10: Maintenance And Care

    ONE PIECE TOILET CLEANING & TROUBLESHOOTING (FILL VALVE) FILL VALVE CLEANING Shut o water supply line Carefully, take out the lter from Use water to wash and clean the Re-install the lter and re-con- before lter cleaning. inlet by using pliers. lter and adapter from any nect the water supply line.

Table of Contents