Voxelab Aries User Manual page 21

1. The adhesion of glass build plate may decrease after long time using. Please apply
proper amount of glue to keep and improve the adhesion.
2. Warping issues may occur when print ABS filament in cold environment, you may use
glue to enhance the adhesion. It's not recommended to print ABS filament at extreme-
ly low temperature environment, as print will fail when printed model getting away
from the build plate.
3. There is a certain quivering on the build plate during the printing which may cause
flatness changed. Thus please pay attention to the adhesion of the first layer when
printing model; if the distance of build plate and nozzle is improper, please re-level it.
4. If printing effect is not accurate enough, check the tension of synchronous belt and
make it neither too loose nor too tight. When synchronous belt working well, check the
transmission ratio under Setting. Turn up the transmission ratio if the size gets smaller,
or turns down the ratio if the size gets larger.
5. If X-axis assembly shakes, adjust the distance between the pulley and the structural
section properly using an open-end wrench; the pulley is well adjusted when you
cannot go on rotating it.
6. Optimal temperature for printing is 18~30℃. Too high or too low temperature is not
good for printing results.
Printing Notice
20