Table of Contents
Advertisement
Figure 25 Single-Port T1 NIC Front Panel Details
Connectors and Cables
To connect the card to a T1 device, use a straight-through RJ-48 cable.
To connect the card to another channel service unit/data service unit (CSU/
DSU), use an RJ-48 crossover cable wired as shown in
You can order appropriate adapter cables separately from Nokia (see
Contact Information"
Warning
Cables connecting to the T1 card must be a minimum of 26 AWG wire.
Caution
Remove the T1 cable before you work on any Nokia appliance.
Caution
Nokia requires that this equipment be installed by authorized,
experienced service personnel who have the equipment installation
instructions. Nokia requires that all equipment be connected to a
Nokia IP1200 Series Security Platform Installation Guide
LOS (red LED)
REMOTE (yellow LED)
SYNC (green LED)
LOOP (yellow LED)
on page 3).
Single-Port T1 NIC
00201
Figure 26
on page 94.
"Nokia
93
Advertisement
Table of Contents
