Nokia IP1200 Series Installation Manual page 132

8
Installing and Replacing Other Components
5. Remove the DIMM by pressing the two retaining clips outward and
6. Press the new DIMM into the socket until it clicks into place.
132
carefully pulling each DIMM upward.
You might need to pull opposite ends of the DIMM alternately to
gradually free it from the contact pins.
Note
You must install DIMMs in pairs starting from the left. Insert a pair of
DIMMS into adjacent slots J5/J6 and/or J7/J8, otherwise the DIMMS
will not work. You can also use all four slots at one time.
The top of the DIMM is smooth. The bottom edge has two different-
length sets of contacts, which mate with the slots on the socket. Be sure
the contacts and slots are properly aligned before you insert the DIMM.
Nokia IP1200 Series Security Platform Installation Guide
00322