Table of Contents
Advertisement
If the presets are being set up for the first time, or significantly altered, it may be
appropriate to erase all previous settings to start afresh as follows:
1.
Select INSTALL from the home menu
2.
Press DOWN or UP or use the rotary encoder to choose GENERAL SETTINGS
menu. Press SELECT.
3.
Press DOWN or UP or use the rotary encoder to choose ERASE ALL
PRESETS menu. Press SELECT.
4.
The screen shows
GENERAL SETTINGS
ERASE ALL PRESETS:
5.
Press EDIT and rotary encoder, choose YES or NO. There will be a check
message before all presets are cleared down.
6. Press SAVE (to record the changes) or CANCEL (to leave the previous settings
unchanged).
Manual dimmer control
It is possible to control any dimmer directly from the front panel of the Processor
using the rotary encoder to set the desired level. This can be used for testing circuits
or overriding control signals or other settings. The level is mixed with any other
incoming signal on a highest level takes precedence basis.
To manually control a dimmer level
1.
Select PRESETS. from the home menu
2.
Press DOWN or UP or use the rotary encoder to choose MANUAL PRESETS
menu. Press SELECT, and EDIT.
3.
The screen shows individual channel numbers with levels.
ENTER MANUAL PRESET VALUES DEVICE 1
CHANNELS
PRESET
4.
Press EDIT and using the <<<< and >>>> buttons, choose the channel to be
adjusted [enabled when square brackets are shown] and set the channel level
by using the rotary encoder. The channel will be set to the level entered from 00
to FF (full). This level will merge with other control levels on a highest takes
precedence basis.
5.
Press ENTER to leave the menu, then either SAVE (to record the changes and
to create a permanent preset state) or CANCEL (to leave the previous settings
unchanged).
Note: The channel is under control as soon as it is activated (square brackets) and the rotary
encoder used to adjust the channel.
30
[NO]
CANCEL SAVE
1
000
EDIT
CANCEL
SAVE
Advertisement
Table of Contents
