Table of Contents
Advertisement
C o n t e n t s
ii
To set up a serial address ...................................... 14
Ethernet .................................................................. 14
To set up the dimmer IP address ........................... 14
To set up the dimmer subnet mask ........................ 15
To set up the dimmer gateway address ................. 15
To set up the merger IP address ............................ 16
To set up the merger subnet mask ......................... 16
To set up the merger gateway address .................. 17
To set up the merger universes .............................. 17
Channel settings ............................................................... 18
Maximum & minimum levels ................................... 18
Response time ........................................................ 18
Dimmer curves ........................................................ 19
Non-dim operation .................................................. 20
Maximum current .................................................... 20
To set up priority channels ...................................... 21
Current limitation ..................................................... 21
Voltage regulation ................................................... 22
Line voltage calibration ........................................... 22
To set voltage regulation ........................................ 23
To set maximum output voltage.............................. 23
Phase-on and Phase-off settings ........................... 23
Start mode .............................................................. 24
Passwords ......................................................................... 25
Presets and manual control functions ............................... 26
To set up digital switch presets .............................. 26
To set up digital switch functions ............................ 26
To reset all presets ................................................. 27
Manual dimmer control ........................................... 27
Local fault reporting .......................................................... 28
To check fault history .............................................. 28
To analyse dimmer status and performance .......... 29
Advertisement
Table of Contents
