Table of Contents
Advertisement
Local fault reporting
If a discrepancy in the normal operating parameters is registered, the Matrix device
will display a red LED for the faulty channel and the Processor will report the
potential fault.
The CHECK light illuminates if a fault is recorded, the STATUS display changes from
OK to CHECK, and any circuit errors are reported on the screen above the channel
number affected as follows:
L1: 245V-38A
DA-X
L2: 247V-14A
DB-X
L3: 242V-20A
RACK : 05 X
SET-DMX
code 'l' =
no load (control present but no output)
code 's' =
short circuit
code 't '=
over temperature
code 'o' =
overload (e.g. 4kW plugged into a 2kW dimmer)
code 'c' =
no control (e.g. load current with no control signal)
code 'v' =
voltage out of range (either over or under voltage)
code 'd' =
fault has persisted beyond a default auto-reset time, and the dimmer
has been disabled awaiting manual intervention and reset.
The channel display indicators give the last recorded fault condition. If the fault is a
self-resetting fault, or if the dimmer is automatically disabled, the reason for the
problem may not be obvious from the channel display. However, a log of the errors is
shown in detail through DimSTAT, and a summary of the history is shown using the
dimmer's LCD screen as follows:
To check fault history
1. Select INFO from the home screen and the screen shows:
Note: This screen never requires a password, and if no faults are reported, the screen
momentarily shows the software version, nominal voltage and maximum current settings. Up to
1024 lines of fault error log are available at any time.
ERROR REPORT
[DEVICE 01
CHANNEL 03: SHORT CIRCUIT]
DOWN
UP RESET-ALL
2.
Press DOWN or UP to check the status history of each channel.
3.
Press RESET to cancel the message, or RESET-ALL to cancel all error
messages.
4.
Press HOME to leave the menu and to return to the home menu.
UA-X
UB-X
PRESETS
CONFIG
RESET
OUTPUTS.
_ o_ |||
STATUS: CHECK
DEVICE: 01X
INSTALL
INFO
HOME
31
Advertisement
Table of Contents
