Table of Contents
Advertisement
parts of the dimmer devices, including the front panel illumination until such time that
the DMX signal is re-established (as soon as the control desk is switched on).
To set the dimmer device to 'Sleep' mode
1.
Select INSTALL from the home menu.
2.
Press DOWN or UP or use the rotary encoder to choose GENERAL SETTINGS
menu. Press SELECT.
3.
Press DOWN or UP or use the rotary encoder to choose SLEEP MODE menu.
Press SELECT.
GENERAL SETTINGS
SLEEP MODE: [OFF]
4.
Use the rotary encoder to choose either ON (active) or OFF (disabled).
5.
Press SAVE to leave the menu and record the changes or CANCEL (to leave
Return to factory settings
The Matrix device is supplied with a set of factory default settings and software set-
up parameters which configure the internal memory and performance characteristics.
It is advisable to reset the dimmer software to the original factory settings in the case
of a significant software update, or when a dimmer device is replaced.
To reset the dimmer device to factory default settings
1.
Select INSTALL from the home menu.
2.
Press DOWN or UP or use the rotary encoder to choose RETURN TO
FACTORY SETTINGS menu. Press SELECT.
RETURN TO FACTORY SETTINGS
ARE YOU REALLY SURE?
3.
Use the rotary encoder to choose either YES (clears memory) or NO (no
action).
4
Press SAVE to leave the menu and reset the dimmer or CANCEL (to leave the
previous settings unchanged).
Factory defaults are:
CHANNEL CONFIGURATION: joined
CURRENT: 43A
CURRENT LIMITATION:
CURVE
DMX-1 ADDRESS:
DMX-1 BACKUP:
34
CANCEL
[NO]
CANCEL
off
LINear
001
all 00
SAVE
SAVE
Advertisement
Table of Contents
