Download Print this page

Simplex 4100-6047 Installation And Programming Manual page 8

Building network interface card
Hide thumbs Also See for 4100-6047:

Advertisement

Programming the BNIC
Software
In order to properly program the BNIC the computer must use FACP System Firmware version
Requirements
1.01 or later. Consult the ES Panel Programmer's Manual (574-849) for more information.
Adding the BNIC
Follow these steps to add the BNIC to the programmer:
to the
1. Start the programmer software.
Programmer
2. Open an existing job or create a new one. If you create a new job you must change the box size
to a 2 or 3 bay box.
3. Select the Hardware tab.
4. Click the Box icon.
5. Right-click the appropriate Bay and select Add a Card. See Figure 7.
6. Select INTERFACE from the Category drop-down menu.
7. Select 4100-6047 - Building Interface Network Card from the Type drop-down menu.
8. Click OK.
Figure 7. Adding a card
Figure 8. Select the BNIC
8
firealarmresources.com
BNIC Installation and Programming Manual

Advertisement

loading

This manual is also suitable for:

4100es