Advertisement
Accessing the FACP through the BNIC
Terminal
To access the FACP from the Building Network once the BNIC has been installed:
Emulation
1. Connect the PC to a Building Network Ethernet port.
2. Start the ES Panel Programmer.
3. Click on Terminal on the Programmer's task bar.
4. Click on Network.
5. Click on Remote Panel. This will automatically launch Tera Term. Tera Term will connect
using the IP information from the current
6. Proceed as you would if you were connected to the FACP through the service port.
job.
Figure 14. Opening Tera Term
12
firealarmresources.com
BNIC Installation and Programming Manual
Advertisement
