Advertisement
Mounting the Card
Mounting the
The BNIC must be mounted in the master controller cabinet and can be placed in any open
BNIC
expansion bay slot.
Use the following steps as well as Figure 5 to properly install the BNIC:
Note: The card must be installed with the ports facing up.
1. Insert the Power Distribution Interface (PDI) connector on the back of the card into one of the
bottom PDI connectors on the expansion bay.
2. Secure the card in place using the provided hardware.
BNIC
(Install with
the ports at
the top)
SCREW
HOLES
EXPANSION
BAY
SCREW RETAINERS
SCREWS
Figure 5. Mounting the BNIC into the Expansion Bay
6
firealarmresources.com
BNIC Installation and Programming Manual
WASHERS
STANDOFFS
Advertisement
