Table of Contents
Advertisement
Display backlight
By pressing any key, the backlight of the display switches on for 60s. The same applies
if the torque value detected by the load sensor will be higher than 0.5% of the full scale
range.
Saving measured values
Measured values can be saved at any time. To do this, press the MEM/ENTER key.
The memory capacity allows you to store up to 500 measurement results, including
measurement units.
Output signal
The measurement result obtained can be transferred to the PC. It is done by pressing
the PRINT key or by interrogating the instrument from the PC. The respective
command can be sent via RS232 or USB.
8
DA-BA-e-2020
Advertisement
Table of Contents
