sauter DA Instruction Manual page 6

CW torque value display function
Load indicator beam
of the clockwise rotation
Display function of the CCW torque value
Load indicator beam
of the counterclockwise rotation
The load indicator bar of the rotation is used to display the load to which the load sensor
is exposed.
When turning clockwise (CW), the load indicator bar moves from right to left. When
turning counterclockwise (CCW), the load indicator bar moves from left to right.
Zeroing the display
During operation it is often necessary to zero the display so that the values already
displayed are not taken into account in the next measurement. To do this, press and
then release the ZERO button.
Changing the measuring unit
Depending on the permissible load of the measuring instrument used, the following
measuring units are available: N-m, kgf-cm, kgf-m, in-lbf, ft-lbf.
To change the measuring unit, press the UNITS key. Each time this key is pressed
again, another measuring unit is displayed until the originally set measuring unit is
displayed. During the selection process, the measurement results are automatically
converted.
Important! It must be remembered that not all units of measurement are always
available. This depends on the permissible load of the respective instrument.
6
Symbol
of the clockwise rotation
Symbol
of the turning process against
clockwise
DA-BA-e-2020