Table of Contents
Advertisement
PASS-FAIL
This function is used to set the permissible torque range. Thus, the upper and the lower
limit value of the torque range are determined. If the torque value falls within the
defined range, the display shows the message PASS (OK). If the torque value detected
is outside the specified range (above or below the range), the display shows FAIL
(NOK). When the PASS-FAIL function is active, the display shows the symbol.
To call up the PASS-FAIL menu screen, position the cursor on the PASS-FAIL function
using the UP or DOWN arrow keys, then press the ENTER key. The display shows the
PASS-FAIL function screen. Press the ESC key to return to the main menu screen.
PASS FAIL MENU
UPPER =
2.
5 N.m
LOWER =
1.0
Press 'Zero' key to
Clear both values.
Use the LEFT arrow key to position the cursor on the selected value. Set the desired
value with the UP or DOWN arrow keys. Press and hold the key to scroll the list. Select
the desired measuring unit with the RIGHT key. Press the ENTER key to save the
setting made and return to the main menu screen.
The PASS-FAIL function is automatically turned off when the setting of the lower limit
(LOWER) and upper limit (UPPER) is 0 N.
The LOWER value must be lower than the UPPER value.
10
PASS FAIL MENU
UPPER LIMIT =
LOWER LIMIT =
N.m
Press the 'Zero' key,
to delete both values.
2.
5 N.m
1.0
N.m
DA-BA-e-2020
Advertisement
Table of Contents
