Error Fix Solutions - Van Der Stahl PTT-100 V Operating Instructions Manual

PTT-100V Operating Instructions Ver.4.03E

16 Error fix solutions

If you are experiencing problems with the machine, please refer to the chart below.
Carefully follow the directions in the operating instructions when replacing parts.
Please consult Van der Stahl Scientific if after referring to the chart, the problem cannot be resolved. Please
refer any questions regarding replacement of parts not listed in the operating instructions or adjustment of such
parts to Van der Stahl Scientific.
ERROR No
ERROR 55 Speed error
Overload
ERROR 56
(Exceeding the
rated capacity)
ERROR 57 Load-cell error
ERROR 58 Load-cell error
ERROR 59 Motor control error
ERROR 60 Error Jamming
ERROR 80 Memory error
ERROR 90 Timer error
ERROR 91 Battery error
WARNING Overload
44
Description
The peel speed is out of speed
range (±5mm/min.).
The peel strength exceeded the
rated capacity (100N)
The load is applied to the load cell
while the clamp base is returning to
the initial position.
There is more than ±3N load applied
to the load-cell when the test is
starting.
The motor detected overload.
This error is displayed when the grip
speed changes.
An error was detected while writing
data on the memory.
An error of the internal clock.
The voltage of the backup battery is
low.
Excessive load is applied to the
load-cell during idling.
Cause
Please contact your local dealer.
Press the ENTER button to return to the
clock display.
Press the ENTER button to return the grip
to the initial position. This error is displayed
to prevent the damage to the machine, and
does not indicate the machine problem.
This error is displayed to prevent the
damage to the machine, and does not
indicate the machine problem.
Press the ENTER button to return to the
clock display.
measurement side. Restart the PTT-100V.
Check if the foreign object is stuck under the
grip on the moving side.
Check if the foreign object is stuck under the
grip on the moving side.
Press the ENTER button to return to the
clock display.
Please contact your local dealer.
Set the date/ time again.
This message may be displayed when the
rapid decrease in power voltage occurs.
Press the ENTER button to return to the
clock display.
The replacement of the battery is required.
Please contact or your local dealer.
Press the ENTER button to return to the
clock display.
Remove the load. Contact your local dealer
when the warning continues.
Solutions