Fuse Replacement - Van Der Stahl PTT-100 V Operating Instructions Manual

13-2 Fuse replacement

You will need: a flathead screwdriver
PTT-100V uses the fuse with the following
specification:
Maximum rated voltage: 250V
Maximum rated current:
Type:
1 Two fuse holders are located above the inlet for
the power cord. Turn the cap counterclockwise
using a flathead screwdriver and remove the
fuse holder.
Set a new fuse to the fuse holder, and return it
2
to where it was.
Be sure to use the fuse that meets
Caution
the specified voltage/ current/ type.
Turn OFF the power switch and
unplug the cord before replacing
the fuse.
Do not short-circuit the fuse holder.
2A
FAST
PTT-100V Operating Instructions Ver.4.03E
Remove
Flathead
screwdriver
Install
Remove
Fuse holder
Power cord connector
Install
41