Operation Procedure - With The Inspection Mode 2 - Van Der Stahl PTT-100 V Operating Instructions Manual

PTT-100V Operating Instructions Ver.4.03E

7-2 Operation procedure - with the inspection mode 2 -

With the Inspection Mode 2, the VIU and PTT inspections are performed as one set.
Please note that the Operators cannot change the setting when the Administrator ID is
Attention
registered and activated
00 ID: ADMINIST
ADMIN password will be
required to cancel the error if
logged in as Operator and
ADMIN is activated.
34
.
VIU 0001
FILM OFF
ERROR SAMPLE 1
PUSH ENTER KEY
Select the desired seal
failure number from 1 to 9.
PASSWORD<000000>
DATE <**.**.**>
TIME <**:**:**>
VIU Inspection
PUSH KEY
PASS or FAIL
Inspection is complete.
VIU 0001
FILM ON
Peel tensile test
1 : PATTERN 1
10mm/300mm/AUTO
Select the desired
operation pattern.
FILM SET 0001
PUSH START KEY
NG 51 MAX LOWER
PUSH SETUP KEY
Refer to "8 Error display for
the detail.
00 ID: ADMINIST
PASSWORD<000000>
ADMIN password will be
required to cancel the error if
logged in as Operator and
ADMIN is activated.