Table of Contents
Advertisement
RE-INSTALLING THE ACCESS PANEL
After all terminations have been made, and setup and configuration have been completed,
gently push the controller board back up into the enclosure.
Remove the excess cable from the enclosure and securely tighten each of the cable gland
connectors on the access panel.
Do not over-tighten these connectors but make certain they are snug.
DO NOT USE TOOLS! Finger-tighten only!
Make certain no cables or wires are exposed between the enclosure and access panel, and
that the hinged AC power terminal is pushed up into the enclosure, then place the access
panel and on the enclosure.
Install the twelve acorn nuts removed earlier, starting with the acorn nut on the left corner
(facing from the bottom of the enclosure) and then moving to the one on the right. Move to the
next acorn nut on the left and repeat this process until all fourteen acorns are installed. See
Figure No. 20.
IMPORTANT! The acorn nuts should be torqued to 20 to 25 in-lb (2.3 to 2.8 Nm).
This mode is automatic and is set to be in higher priority than serial communication. That
means if the controller board has an option card attached, the controller board will display
OPT:CARDNAME
after the Rev version and SB600 welcome message for 2 seconds and then display weight.
During this mode, the controller board will only look for data from the option card and will
ignore serial data.
Currently, support option cards include:
• 2XX-SNAP – SnapStream card
• 2XX-SFP-G – Serial Fiber Optic Option Card
32
Install this acorn nut first.
FIGURE NO. 20
OPTION CARD CONFIGURATION
3601-0756-0M Rev D • SB600
(OPTION and the CARD NAME)
Advertisement
Table of Contents
