Table of Contents
Advertisement
SETUP AND CONFIGURATION, CONT.
TRAFFIC LIGHT
LED 1, 2, 3, A AND B (on Controller Board)
IMPORTANT! Traffic light control requires the model SB600RI (with Remote
Input). Contact the factory for details before placing your order.
The TRAFFIC LIGHT setting allows setup to configure the scoreboard to control the
traffic light through the serial stream or from 1 or 2 inputs.
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values from 0 to 3 may be selected.
0: SERIAL STREAM = Traffic light controlled through the serial stream
1: INPUT 1 RED = Input 1 is used and Red is default off
2: INPUT 1 GREEN = Input 1 is used and Green is default off
3: INPUT 1 AND 2 = Both inputs 1 and 2 are used
Input 1 turns on Red and input 2 turns on Green
28
3601-0756-0M Rev D • SB600
Advertisement
Table of Contents
