Table of Contents
Advertisement
SETUP AND CONFIGURATION, CONT.
BAUD RATE
LED 5 (on Controller Board)
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values from 0 to 7 may be selected.
0: = Auto Baud *
1: = 2400
2: = 4800
If you are using the Auto Baud feature you will see BD:? at the beginning of the
test. This test can only complete if there is data communication coming down the line.
If the SB600 cannot determine the baud rate it will display BD:FAIL. If it passes it
will display BD:9600. If no data is being transmitted to the SB600 then BD:? will
continue to be displayed. If BD:FAIL occurs the SB600 will try to determine the
baud rate again one second later.
SERIAL FORMAT
LED 6 (on Controller Board)
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting, and then press the MODE switch to save it and complete
setup and configuration. Values from 0 to 2 may be selected.
0: (7, E, 1) = 7 data, even parity, 1 stop bit
1: (7, 0, 1) = 7 data, odd parity, 1 stop bit
2: (8, N, 1) = 8 data, no parity, 1 stop bit
NOTE: If the Baud Rate is set for Auto Baud, the serial format is
automatically detected from one of the above formats. At the beginning of the
test, using the auto baud feature you will see SF:?. If the SB600 cannot
determine the serial format it will display SF:FAIL
24
3: = 9600
4: = 19,200
5: = 38,400
(FOR TRANSMIT ONLY)
3601-0756-0M Rev D • SB600
6: = 57,600
7: = 115,200
Factory Default
Advertisement
Table of Contents
