Table of Contents
Advertisement
SETUP AND CONFIGURATION, CONT.
SWITCHED OP
LED A (on Controller Board)
The SWITCHED OP setting enables switched operation utilizing a customer-supplied
remote toggle switch and does not require serial input to display the message pairs
below. The messages are driven from the current-loop input on the terminal block. Note
that when SWITCHED OP is enabled (set to 1 to 9), the serial input to the SB600 is
disabled. Also, note that the factory default value is 0 (serial input is enabled).
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values from 0 to 9 may be selected.
0: DISABLED (Serial Input Enabled)
1: OPEN/CLOSED
2: GO/STOP
3: ON/OFF
4: START/STOP
Factory Default
To use the switched operation, Receive Mode jumper J1/J2, must be ON the CL pins
(J1). In addition, on the P6 terminal connector, jumper terminals CS2 and CL RX+
together and then connect the operation toggle switch across terminals CL RX- and
GND. Refer to Figure No. 14 for the location of J1/J2, P6, and the connection
descriptions.
SUP. LEAD ZERO
LED B (on Controller Board)
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next
setup parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values of 0 or 1 may be selected
0: NO = No Suppression
(OPERATION MESSAGE SETTING)
(SUPPRESS LEADING ZEROS)
1: YES = Suppress Zeros (DEFAULT)
3601-0756-0M Rev D • SB600
5: WALK/WAIT
6: LEFT/RIGHT
7: UP/DOWN
8: ENTER/EXIT
9: SPACES/
25
Advertisement
Table of Contents
