Table of Contents
Advertisement
RE-INSTALLING THE FRONT PANEL
After all the terminations have been made, changes to setup have been completed, and the
display brightness set to the desired level, it's time to re-install the front panel.
Gently pull any excess cable (AC power and serial) from the enclosure.
1.
Securely tighten the cable gland connectors.
2.
• Do not over-tighten the connectors but make certain they are snug.
• DO NOT USE TOOLS! Finger-tighten only!
• Ensure that any unused gland connectors are plugged.
Make certain no cables or wires are exposed between the rear housing and front panel.
3.
Place the front panel onto the rear housing.
4.
Secure with the 12 screws removed earlier.
5.
Follow a diagonal pattern when tightening the screws.
6.
The RD3 Remote Display is equipped with software that tests various portions of its circuitry
and verifies proper operation. Should a problem be detected, a message will be displayed. The
following lists the messages displayed and their meaning:
Display
auto-b
Erro1
Erro2
autofo
Erro3
Nodata
16
8200-M063-O1 Rev C RD3 Installation and Technical Manual
ERROR AND STATUS DISPLAYS
This will be displayed for a maximum of 4 seconds when the display is
configured for Auto-baud detection. Note that while detecting the baud
rate, the intensity of the digits will increase to full brightness.
The auto-baud feature could not detect the baud rate of the indicator.
Verify baud rate of the indicator serial port is set for 2400 to 19200 baud
and try again. If an error continues, manually set the baud rate of the
display and indicator.
This will be displayed for a maximum of 3 seconds when the display is
configured for Auto-format.
The auto-format feature was unable to automatically select a serial input
protocol. Verify indicator serial output is one of the eight serial formats
listed in Setup and Configuration and try again. If an error continues,
manually set the serial format of the display and indicator.
On some indicators, the serial output will stop when displaying an error
code or if in an "input" mode. When the serial input to the display stops
for any reason, after 3 seconds this message will be displayed.
• Correct error condition on the indicator.
• Cancel or complete the input operation on the indicator.
This message could also indicate the serial connection between the
indicator and the display has been lost.
• Check for a broken, loose, or disconnected serial cable between the
indicator and the display.
Meaning
Advertisement
Table of Contents
