Table of Contents
Advertisement
SETUP AND CONFIGURATION, CONT.
MODE OF OP
LED 4 (on Controller Board)
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values from 0 to 2 may be selected.
0: MESSAGE BOARD = Message-board format
1: SCOREBOARD = Normal scoreboard format (DEFAULT)
2: SCOREBOARD NO TIMEOUT = Scoreboard format with no timeout.
If MODE OF OP = 0, the data format for the serial input to the message board is:
%NDDDDDDDDD<CR>
where:
If MODE OF OP = 1 or 2, the data format for the serial input to the scoreboard is:
%NDDDDDDUUMT<CR>
where:
22
(MODE OF OPERATION)
N = Panel number for a daisy chain configuration
D = Byte of data to display at respective location on the scoreboard
<CR> = Carriage Return
N = Panel number for a daisy chain configuration
D = Byte of data to display at respective location on the scoreboard
UU = Units (lb, kg, T, t)
M = Mode (G = Gross or N = Net)
T = Control character for the traffic light.
Valid characters for T are:
For the Valid characters for T, refer to the list on the next page.
3601-0756-0M Rev D • SB600
Advertisement
Table of Contents
