Table of Contents
Advertisement
SETUP AND CONFIGURATION, CONT.
RS485 ADDRESS
LED 3
(on Controller Board)
The 7-segment LED (U6) and the scoreboard will show the current value. If the setting
displayed is acceptable, press the MODE switch to save it and advance to the next setup
parameter.
Otherwise, using the (+) switch to increase the value or the (−) switch to decrease the
value, select the new setting and then press the MODE switch to save it and advance to
the next setup parameter. Values from OFF to F may be selected.
ADDR: OFF through F
NOTE: When using the RS485 protocol, data is only displayed if the correct
address is detected.
The data format for the RS485 serial input is:
%ADDDDDDDDD<CR>
where:
A = address byte
D = byte of data for display (at least 9 bytes, decimal points, and commas are
considered part of the preceding digit and may be inserted at any location)
<CR> = carriage return
NOTES:
• The weight/units/mode information must be correctly positioned; no translation is
performed on the data sent.
• If the address is set to 0 (zero), the RS485 operation is disabled, and the
scoreboard will default to daisy chain operation if the RS485 protocol is used.
• In daisy chain operation, if the address is greater than 0, the scoreboard will
decrement the address and send the data out of the serial port to another daisy-
chained scoreboard.
3601-0756-0M Rev D • SB600
21
Advertisement
Table of Contents
