Network Menu - Oki C8800 User Manual

Network Menu

This menu controls the operation of the printer's 10Base-T/
100Base-TX network interface.
Notes:
Factory default settings are shown in
Settings with a dagger (†) only appear when the
appropriate option is installed.
Item
TCP/IP
IP VERSION
NETBEUI
NETWARE
ETHERTALK
FRAME TYPE
IP ADDRESS
SET
IP ADDRESS
SUBNET MASK
GATEWAY
ADDRESS
FACTORY
DEFAULTS
WEB
Settings
ENABLE /
DISABLE
IP V4 / IPV 4 &
V6
ENABLE /
DISABLE
ENABLE /
DISABLE
ENABLE /
DISABLE
AUTO / 802.2 /
802.3 /
ETHERNET II /
SNAP
AUTO /
MANUAL
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
xxx.xxx.xxx.xxx
EXECUTE
ENABLE /
DISABLE
C8800 User's Guide
Explanation
Enables or disables this network
protocol.
Enables or disables this network
protocol.
Enables or disables this network
protocol.
Enables or disables this network
protocol.
Selects the Ethernet MAC layer frame
type.
Specifies whether IP address allocation
is automatic (DHCP) or manually
assigned.
Current assigned IP address. To
change, press ENTER and use +/–
keys to increment 1st octet, then press
ENTER again to move on to next octet.
When 4th octet has been set, press
ENTER again to register new address.
Current assigned subnet mask. To
change, proceed as above.
Current assigned gateway address. To
change, proceed as above.
Reloads the settings present when the
unit was setup by the manufacturer.
Enables or disables Web config. facility.
111
.
bold