Font Panel Operation; Changing Ip Address From Front Panel - Hall Technologies FHD264 User Manual

4.1 Font Panel Operation

Use the front panel to change the Group ID, IP Configuration and RS-232
Baud Rate. By default, after the FHD264 gets initialized, it shows the home
screen with Device ID and Group ID. To see the system configuration, click
the MENU Button and use the NAVIGATION (NAV) keys to view various
settings. To change the settings, hold the MENU button until the setting
name starts blinking. Use NAV keys to change the parameters of the setting
and click MENU to apply setting or Hold MENU to discard setting. Follow the
messages on the LCD for further instructions.

4.1.1 Changing IP address from Front panel

To change the IP address from the front panel, make sure DHCP is turned
OFF. The steps are as follows
1. From Home Screen push MENU
2. NAV to IP configuration ("-- IP--")
3. Hold MENU until setting name ("--IP--") starts blinking
4. By default, the first octet in the IP address starts blinking
5. Use NAV keys to change the octet parameter or click MENU to move
to the next octet
6. After the reaching the 4th octet, click MENU to change the IP
address.
7. At any point time, if the setting name is blinking, hold MENU to
discard the changes
Figure 6 - Front panel operation
© Copyright 2019 Hall Research, Inc.
11