Dynamic Virtual Matrix Manager Tool - Hall Technologies FHD264 User Manual

All Commands are
Terminated by <CR><LF>
(or Hex 0D 0A)
set_device_name [string (1~30)]
Where string can be 30 characters
long
get_device_name
get_fw_version
factory_reset
Reboot
get_company_id
set_streaming_mode
[string(unicast|multicast)]
get_streaming_mode
[string(unicast|multicast)]
master_get
master_set
[string(xxx.xxx.xxx.xxx)]
rs_out
[string( up to 100 char)]
get_failsafe (Receiver ONLY)
set_failsafe
[string(on|off)] (Receiver ONLY)
set_fs_group n
where n = 0 to 63 (Receiver ONLY)
get_fs_group (Receiver ONLY)
Exit

4.4 Dynamic Virtual Matrix Manager Tool

•
The free Hall Research Windows™ Dynamic Virtual Matrix Manager
Tool can locate all the FHD264 devices on the network.
•
It will list all the devices found by User-defined names, IP addresses,
and Multicast Group channels.
16
© Copyright 2019 Hall Technologies
Response
OK – Success
Error – Fail
[string (1~30)]
Tx/Rx Firmware : x.x.x.x.xxxxxxxx
Returns the firwmare version
Processing factory reset!
System will reboot after few sec!
System will reboot after few sec!
xxx
OK – Success
Error – Fail
[string(unicast|multicast)]
where unicast means one-one
configuration and
multicast means one to many and
many-to-many configuration
xxx.xxx.xxx.xxx (IP Address)
[Blank]
Master Set
SoIP Sent
on
off
Ok -- Successes
Error -- Fail
Ok -- Successes
Error -- Fail
Number in range 0 to 63
Function
Set the device name
Query the device name
Query the firmware version
Factory reset the device
To reboot the unit
Query the company ID
Set the streaming mode of
the device
Query streaming mode
status
Return the IP address of
registered 3rd party
controller for SoIP
Registers the IP address as
3rd party controller. All the
responses from the serial
device connected to RS-
232 port will be sent to the
server on port #5050 at
this IP address
Outputs the string the
string via RS-232
Returns the fail safe status
Set the fail safe status
Set the fail safe group
number
Returns the fail safe group
number
Exits the telnet session