Table of Contents
Advertisement
Note:
• Commands are case sensitive - use lowercase characters as shown.
• Invalid commands result in "Unknown Input Command !!!"
• The "list <CR>" command displays the list of available commands.
All Commands are
Terminated by <CR><LF>
(or Hex 0D 0A)
set_group_id n
where n=0-1023
get_group_id
set_dhcp
get_dhcp
Set_uart_baudrate n
Where n = 2400, 4800, 9600, 19200,
28800, 28400, 57600, 115200
get_uart_baudrate
set_static_ip ip [ip(n.n.n.n)]
netmask [ip(n.n.n.n)]
gateway [ip(n.n.n.n)]
Where:
ip [ip(n.n.n.n)] =IP xxx. xxx. xxx. xxx
netmask[ip(n.n.n.n)]=netmask
255.255.xxx.xxx
gateway [ip(n.n.n.n)] = gateway xxx.
xxx. xxx. xxx
get_static_ip
get_mac_address
get_lan_status
get_ip_config
14
© Copyright 2019 Hall Technologies
Figure 10 - Telnet terminal message
Response
OK – Success
Error – Fail
n
where 'n" returns the group ID
OK – Success
Error – Fail
On – DHCP
Off – No DHCP
OK – Success
Error – Fail
n
where n = baud rate
OK – Success
Error – Fail
IP: 192.168.1.xx
Netmask: 255.255.0.0
Gateway: 192.168.1.1
XX: XX:XX:XX:XX:XX
Link_Up/Link_Down
IP:
XXX.XXX.XXX.XXX
Netmask:
XXX.XXX.XXX.XXX
Gateway:
XXX.XXX.XXX.XXX
Function
Set Group ID
Query the current group ID
status
Set to DHCP mode
Query the DHCP status
Set the baud rate for the
RS-232 on the unit
Query the current baud rate
setting in the unit
Set the static IP
configuration for the unit
Returns the current static
IP configuration
Query the MAC address of
the unit
Query LAN Status whether
device is UP and
connected to the switch
Shows IP Configuration
settings
Advertisement
Table of Contents
