Video Scaling And Bit Rate Control - Hall Technologies FHD264 User Manual

5.7 IR
FHD264 Supports both IR pass through and IR Control using a single
wideband IR detector. Any IR signal received in the range of 32-56 KHz at the
Receiver will be sent to the Sender in the group. The Sender can receive IR
signals from multiple receivers on a first come, first served basis. This allows
the user to control the IR devices at the Sender end from multiple Receiver
locations. Note that to send an IR signal to a device at the Sender end, the
Receiver must be in the same group as the Sender.
Additionally, each FHD264-R comes with an IR Remote
control that works at a frequency of 56 KHz. The IR
Remote can be used to quickly change Receiver groups:
•
Use NAV keys to increment or decrement the
group by one
•
Use NUM pad to go to any group in the range of 0 to
63
•
Keys A and B are reserved for future use

5.8 Video Scaling and Bit Rate Control

The FHD264-S (Sender) has internal video scaling capabilities. The user can
control the bit rate and scaling feature depending on the network bandwidth.
The user can change the settings in three ways – WebGUI, Telnet, or PC GUI.
Please consider the following if you decide to change settings from default:
•
The input of the sender is the source video fed into the sender.
22
© Copyright 2019 Hall Technologies
Figure 18 – IR
Figure 19- IR Remote Controller