Cooling Pads - Seeley Aira AL Series Installation And Operation Manual

INSTALLATION INFORMATION

3.4.6 Cooling Pads

All units have removable cooling pads that provide access to the internal components of the cooler.
The following steps can be used to remove cooling pads.
1. Confirm that the unit is not operating and that the power is isolated. Do not remove pads whilst the unit is
operational.
2. Lift pad vertically using the handle on the pad frame assembly shown in Figure 15: Cooling Pads
3. Angle the bottom of the pad and pull out of the unit bottom first
The following steps can be used to install cooling pads.
1. Confirm that the unit is not operating and that the power is isolated. Do not remove pads whilst the unit is
operational.
2. Place the pad frame assemblies top first into the unit framework.
3. Lift the pad using the handle and align the bottom of the pad with the corresponding slot in the unit framework.
4. Carefully lower the pad frame assembly and confirm that it is held in position by the unit frame.
UNIT FRAME
COOLING PAD
PAD HANDLE
|
20
Figure 15: Cooling Pads
AMI105-A