Advertisement
Notes
Scope of Use: GPURE Range
Installation is subject to the regulatory requirements of the plumbing
code of Australia associated to AS/NZS 3500.1 (Bubblers) and AS/NZS
3500.4 (Taps)
Inlet pressure: Maximum 500 kpa
Manufacturers recommended pressure: 350 kpa
Installation: Refer to manufacturer's instructions for installation
Water quality: In line strainer (supplied) must be installed to ensure
water quality
Suitable for indoor and outdoor use: GPURE FLOSTOP & GPURE
BUBBLERS
Suitable for indoor use only: GPURE JETFLO, GPURE CLEANLINE,
GPURE NUGEN
Temperature recommendation:
Material: Stainless Steel (316) / Stainless Steel (304)
Mounting: Wall, bench or in line installation
*For optimum operational life water pressures between 150kPa and 450kPa are recommended
11
Single temperature up to 50 c
Dual temperature up to 80 c
Minimum temperature: 5 c
Advertisement
