Hilti SID 14-A Original Operating Instructions page 16

6. Fit the O-ring on the socket.
7. Before using the power tool, check that the accessory tool is correctly seated and secure.
6 Operation
Observe the safety instructions and warnings in this documentation and on the product.
6.1 Setting the torque
▶ Repeatedly press the torque selector switch until the desired torque setting is indicated by the indicator
on the left beside the switch.
SID 14­A
SID 22­A
Model SID ... → page 7
SIW 14­A
SIW 22­A
Model SIW ... → page 8
6.2 Setting forward or reverse rotation
An interlock prevents switching while the motor is running.
The control switch is locked when the forward/reverse switch is in the middle position (safety lock).
▶ Set the forward/reverse switch to the desired direction of rotation.
6.3 Switching on
▶ Press the control switch.
▶ Speed of rotation is regulated by the distance the control switch is pressed in.
6.4 Screwdriving
CAUTION
Risk of injury by damaged workpieces! Screws or workpiece can be damaged if torque is too high. This
presents a risk of injury.
▶ Make sure that screws and workpiece are suitable for the torque produced by the tool.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Use the torque selector switch to set the desired torque. → page 10
6.5 Switching off
▶ Release the control switch.
6.6 Removing the accessory tool
SID 14­A
SID 22­A
CAUTION
Risk of injury by the accessory tool! The accessory tool might be hot or have sharp edges.
▶ Wear protective gloves when using the power tool and when changing accessory tools.
1. Set the forward/reverse switch to the middle position or remove the battery from the power tool.
2. Pull the chuck ring forward and hold it in this position.
3. Pull the accessory tool out of the chuck.
4. Release the chuck ring.
10 English
6
7
8
2072653
*2072653*