Hilti SID 14-A Original Operating Instructions page 14

Model SIW ...
SIW 14­A
SIW 22­A
Torque
Torque
4.3 Battery, 14.4 V
Battery operating voltage
Ambient temperature
Storage temperature
4.4 Battery, 21.6 V
Battery operating voltage
Ambient temperature
Storage temperature
5 Preparations at the workplace
CAUTION
Risk of injury by inadvertent starting!
▶ Before inserting the battery, make sure that the product is switched off.
▶ Remove the battery before making any adjustments to the power tool or before changing accessories.
Observe the safety instructions and warnings in this documentation and on the product.
5.1 Charging the battery
1. Before charging the battery, read the operating instructions for the charger.
2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.
3. Use an approved charger to charge the battery.
5.2 Inserting the battery
CAUTION
Risk of injury by short circuit or falling battery!
▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product
are free of foreign matter.
▶ Make sure that the battery always engages correctly.
1. Charge the battery fully before using it for the first time.
2. Push the battery into the battery holder until it engages with an audible click.
3. Check that the battery is seated securely.
8 English
SIW 14­A
1/2" square drive with
ball-notch retention
Setting I 80 Nm
Setting II 120 Nm
Setting III 185 Nm
SIW 22­A
1/2" square drive with
ball-notch retention
Setting I 90 Nm
Setting II 135 Nm
Setting III 200 Nm
3/8" square drive with
locking ring
65 Nm
115 Nm
160 Nm
3/8" square drive with
locking ring
75 Nm
120 Nm
175 Nm
14.4 V
−10 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
21.6 V
−17 ℃ ... 60 ℃
−20 ℃ ... 40 ℃
2072653
*2072653*