MORLEY-IAS
Key Legend Symbol
0 to 9
>
<
Change
M
Enter
No
Yes
Shift
•
The control keys are disabled at USER LEVEL 1. Pressing the SHIFT key will cause the display to
prompt for entry of the Level 2 password. The password must be entered to re-enable the control keys
at Level 2.
3.2 Front Panel LED Indications
•
The Level 1 LED Indicators are divided
into two sections.
•
The upper array of LED Indicators shows
the operational conditional of the panel
and the installation.
•
The lower array of Zone LED indicators
shows the location of a fire alarm or fault.
•
The standard Zone LED Indicators
provide identification for up to 20 zones.
On the ZX5Se and ZX10Se panels, this
can be extended by adding either a further
20 zones (to give a total of 40 zones) or a
further 60 zones (to give a total of 80
zones).
•
The LED Indicators illuminate as red,
yellow or green to give a clear indication
of the panel status as follows:
Page 6
Press to enter numbers 0-9 or letters A-J (N-W with Shift)
Press to scroll through fire alarms or faults manually on the display or
letter K (X with Shift)
Press to scroll back through fire alarms or faults manually on the
display or letter Z (Y with Shift)
Press to change a display option (where allowed)
or letter M (Z with Shift)
Z
Press to confirm entry of a multiple digit number
Press to answer No, or terminate a display option
Press to answer Yes, or step through a display option
Press to show user options on the display
Press, during programming, to allow entry of Letters N-Z
Table 2 – Alphanumeric and Interactive Control Keys
Document No. 996-175-000-1, Revision 01
ZX Fire Alarm Control Panels
Function
FIRE
FAULT
Acknowledged
Disablement
Test
Sounder Fault
Delayed Mode
Relays Disabled
Earth Fault
System / CPU Fault
Sounders Disabled
Alarms Silenced
Supply Fault
Power
Figure 3 – System Control LED Display
Commissioning Manual