Canon Pixma MX338 Getting Started page 36

Table of Contents

Advertisement

Try Copying
嘗試影印
복사해 보기
You can copy a document by simply placing it on the Platen Glass and pressing the Start button.
This section explains with Plain Paper. For various copying procedures, refer to "Copying" in the on-screen manual: Basic Guide.
只需將文件放置到原稿玻璃上並按啟動按鈕即可影印文件。
本節使用一般紙張進行說明。關於各種影印操作步驟,請參閱電子手冊: 《基本指南》中的「影印」 。
문서를 평판 유리 위에 놓고 시작 버튼을 눌러 쉽게 이를 복사할 수 있습니다.
이 절은 보통 용지로 절차를 설명합니다. 다양한 복사 절차에 대한 내용은 기본 가이드 전자 안내서에서 "복사하기"를 참조하십시오.
1
Load a sheet of A4 or Letter-sized Plain Paper.
載入一張 A4 或 Letter 大小的一般紙張。
A4 또는 Letter 크기의 보통 용지 한 장을 로드합니다.
For details, refer to "8 Loading Paper" on page 29.
The machine may make operating noise when feeding paper. This
is normal operation.
關於詳細資訊,請參閱第 29 頁的「8 載入紙張」 。
在送紙時本機可能發出運行噪音。這是正常的運行。
자세한 내용은 29페이지의 "8 용지 로드하기"를 참조하십시오.
용지를 공급하는 동안 기기에서 작동 소음이 날 수 있습니다. 이는
정상적인 작동 현상입니다.

2
Open the Document Cover (A).
開啟文件蓋板 (A)。
문서 커버(A)를 엽니다.
3
Place the document face-
down and align it with the
Alignment Mark (B).
Do not place any objects weighing more than 4.4 lb / 2.0
kg on the Platen Glass (C).
Do not press or put weight on the original with pressure
exceeding 4.4 lb / 2.0 kg. Doing so may cause the
scanner to malfunction or the Platen Glass to break.
將文件面向下放置並使其與對
準標記 (B) 對齊。
請勿在原稿玻璃 (C) 上放置任何重量超過 4.4 lb / 2.0 kg
的物件。
請勿按壓原稿或在原稿上置放重物,使原稿承受的壓力超
문서를 복사면이 아래로 향하
過 4.4lb/2.0kg。否則可能導致掃描器發生故障或原稿玻璃
碎裂。
게 하여 놓고 이를 정렬 표시
(B)와 맞춥니다.
무게가 4.4lb/2.0kg 이상인 물체를 평판 유리(C) 위에 올
려놓지 마십시오.
원본을 4.4lb/2.0kg 이상의 압력으로 누르거나 하중을 가
하지 마십시오. 이는 스캐너를 고장나게 하거나 평판 유
리를 깨지게 할 수 있습니다.
B
C

Advertisement

Table of Contents
loading

Table of Contents