Preparing The Graphics Card; Removing The Stock Cooler; Cleaning The Pcb - EK Quantum Vector2 RE RTX 3080 ABP Set D-RGB User Manual

Gpu water block with active backplate

Hide thumbs Also See for Quantum Vector2 RE RTX 3080 ABP Set D-RGB:

Table of Contents

PREPARING THE GRAPHICS CARD

STEP 1

Place your graphics card on the flat surface and carefully remove

the stock cooler. Do not forget to unplug all the LED and fan

connectors. Pay attention to the following steps in order to install

the EK-Quantum Vector

block onto the graphics card.

STEP 2

Wipe off the remains of the original thermal compound using a

nonabrasive cloth or Q-tip, as shown in the sample image, until

the components and the circuit board are completely clean. EK

recommends the use of denatured alcohol for removing TIM

leftovers. After that, remove all remaining stock thermal pads from

the PCB.

STEP 2

- 8 -

RE RTX 3080/90 ABP Set D-RGB water

Always remove the stock cooler slowly - it might be

firmly glued to the PCB via thermal pads.

Table of Contents

Do you have a question about the Quantum Vector2 RE RTX 3080 ABP Set D-RGB and is the answer not in the manual?

Quantum vector2 re rtx 3090 abp set d-rgb