EK Quantum Vector2 RE RTX 3080 ABP Set D-RGB User Manual page 13

3
7
2
1
6 4
1
STANDOFF M2.5-M3 x 6.6
(5x)
3
2
AX1 M2.5x4 SCREW (6x)
POLYAMID WASHER (6x)
5
STEP 2
4
5
STEP 3
STEP 2
After placing a PCB on the water block, use AX1 M2.5x4 screws and
polyamide washers to tighten the PCB on the water block.
Do not forget to put polyamide washers between the PCB and
screws! Tighten the screws according to the number order
shown in the image!
Do not use excessive force!
Do not use moment higher than 0.6 Nm!
For this step, you will need:
M2.5 x 4 AX1
Screw (7 pcs)
STEP 3
Position the M2.5-M3 x 6.6 standoffs with holes of M3.5-M2.5 x
11.3 and M3.5-M2.5 x 3 standoffs, as shown in the image. Tighten
them evenly with the EK-Plug-Out Spludger Tool (EAN 104299).
Tighten the screws according to the number order shown in the image!
Do not use excessive force!
Do not use moment higher than 0.6 Nm!
For this step, you will need:
EK-Plug Out Spludger Tool
- 13 -
Polyamide Washer Phillips Head
(7 pcs) Screwdriver